Description
Flat bed (Mechanic/welder?)
Year – 2017
Engine – Toyota diesel
Hour: 3356
Axles- Dana c/w wet disc brakes
Rear section – ROPS/FOPS certified
Frame- re-enforced heavy duty frame
Price – T.B.A. (flat bed only)
Price – T.B.A. (with Miller 325 welder)
Here is a list of some of the work we did to get this truck ready:
Rear axle -new brake discs and seals -new pinion seal -new wheel bearings -new oil c/w anti chatter additive -new tie bolts – new hub seals- new shocks- all cavities pressure tested OK
Front axle -new u-joints in CV -new shaft seals in CV -new steering knuckle bushings -adjust steer stops – rebuilt steer cylinder with re-chromed rod- new wheel bearings and hub seals- new shocks-all cavities pressure tested OK
Engine -set valve clearance to OEM spec. -new timing cover gasket -new valve cover gasket -new oil, filter and air filter – reseal oil pan- complete new exhaust system
Transmission -new oil -new clutch slave cylinder
Rear – new floor- new side plates
Gear box -new oil
Cab -new windshield -new front driver door -new inner and outer front fenders -new heavy duty seat covers- ROPS/FOPS canopy- new clutch pedal- new floor on driver side- all new door seals
Frame- Rusted areas were cleaned and then sprayed with rock guard on the entire frame – new front bumper- new rear bumper- frame is solid
General- new fuel tank- new front lights- new blue strobe lights- new rear lights- full service- new battery and terminals- electrical was checked, repaired as required and tested
